FSFabShopSource

Bolt hole edge distance and spacing for steel plates

Minimum edge distance and bolt spacing for base plates, tabs and gussets, with standard hole sizes and a quick reference table from the AISC Specification.

Holes too close to the edge of a plate tear out under load and look wrong to an inspector. Here are the numbers most fabricators work to, from the AISC Specification for Structural Steel Buildings. Always follow the engineer's drawings when you have them.

Standard hole sizes

For bolts smaller than 1", a standard hole is the bolt diameter plus 1/16" (a 3/4" bolt gets a 13/16" hole). For 1" bolts and larger it is the diameter plus 1/8".

Minimum edge distance

Measured from the center of a standard hole to the edge of the plate, any edge:

Bolt diameterMinimum edge distance
1/2"3/4"
5/8"7/8"
3/4"1"
7/8"1-1/8"
1"1-1/4"
1-1/8"1-1/2"
1-1/4"1-5/8"
Over 1-1/4"1.25 × bolt diameter

These are minimums. Many shops use 1.5 × the hole diameter as a quick rule of thumb on tabs and clips, which lands at or above the table for common sizes.

Bolt spacing

The minimum center-to-center spacing is 2-2/3 × the bolt diameter, and 3 × the diameter is preferred. For a 3/4" bolt that is 2" minimum and 2-1/4" preferred.

Anchor rods in base plates

Anchor rod holes in base plates are oversized to allow for placement tolerance in the concrete, usually 1/2" or more over the rod diameter, with heavy plate washers welded or bolted over them. Check the drawings and the AISC Design Guide for base plates for the hole size and washer required.

Draw tabs, base plates and gussets with correct hole placement in the free DXF designer. It shows the edge distance for every hole and exports a cut-ready DXF for your plasma or laser.

Frequently asked questions

What is the minimum edge distance for a 3/4 inch bolt?

1 inch from the center of a standard hole to the edge, per AISC Table J3.4.

What is the minimum spacing between bolt holes?

2-2/3 times the bolt diameter, with 3 times the diameter preferred.

More guides