FSFabShopSource

DXF Designer

Pick a part, enter your sizes, and download a cut-ready DXF for your plasma table or laser. Fractions, decimals or mm.

1:1 scale, inches, layer CUT. Opens in SheetCam, FastCAM, ProNest, Fusion and most table software.

Frequently asked questions

What does the DXF designer make?

Flat plasma and laser parts: mounting tabs (flat or coped to fit round tube), rectangular plates with hole patterns, gussets with a corner clip, and round plates with a bolt circle. Enter the sizes and download a cut-ready DXF.

What units are the DXF files in?

Inches, at 1:1 scale, on one layer named CUT. Outlines are lines and arcs, holes are circles. Type fractions like 1-1/2 or 13/16, decimals, or millimeters (19mm).

How is a tab coped for tube?

Pick Round tube and Across the tube. The bottom of the tab is cut to the tube's radius so it sits tight on the tube, and the hole height is measured from the top of the tube.

Is this engineered?

No. It draws the shape you enter. Check sizes, edge distances and hole sizes against your drawings or engineer before cutting.