FSFabShopSource

Miter Cut Calculator

Enter the angle (or the corner, or the number of sides), the material depth and a length. Get the saw setting and both long point and short point lengths.

Formats: 2 · 1 1/2 · 5'-6 1/2" · 50mm

Pro

Nest mitered parts

The Cut List Optimizer with Pro lines up matching miters so one cut makes two ends, and tells your saw operator which way to flip each piece.

Open the cut list optimizer

The math

Long point to short point, per mitered end = depth × tan(miter angle). For a 45° miter that is simply the depth. The cut face is depth ÷ cos(miter angle) long. Corner miters are (180 − corner angle) ÷ 2, and a frame with N equal sides uses 180 ÷ N on every end.

See the full walk-through in How to calculate miter cuts on tube and angle.

Frequently asked questions

What is the long point and short point of a miter?

On a mitered piece the long point is the tip of the cut on the longer face and the short point is where the cut meets the opposite face. The difference between them, per end, is the material depth times the tangent of the miter angle. A 45 degree miter on 2 inch tube is 2 inches long point to short point.

What miter angle do I cut for a corner?

For two members meeting at a corner, each piece gets half of what is left after subtracting the corner angle from 180. A 90 degree corner is 45 degrees on each piece. A 135 degree corner is 22.5 degrees on each piece.

What angle for a frame with more than four sides?

Divide 180 by the number of sides. A hexagon (6 sides) is 30 degrees on each end of every piece. An octagon (8 sides) is 22.5 degrees.

My saw reads 90 for a square cut. What do I set it to?

Subtract the miter angle from 90. A 45 degree miter is still 45. A 30 degree miter is set at 60 on a saw that reads 90 for square.

Which depth do I use for tube?

Use the tube dimension in the direction of the miter. A 2x3 rectangular tube mitered across its 3 inch face uses 3 inches. Mitered across the 2 inch face it uses 2 inches.

Can I nest mitered parts to save material?

Yes. In the Cut List Optimizer, Quote Builder Pro lines up matching miters so one saw cut makes both ends. You save the long point to short point distance at every shared cut.